Saturday, February 16, 2019

Winnebago-Itasca Motorhome Remote Programming Instructions

This Winnebago-Itasca Motorhome system uses replacement remote: G57ITX318
G57ITX318 Remote

Turn the Ignition ON & OFF.
2. Press & HOLD the receiver square (yellow) reset button for 4 seconds then release it (this yellow button is usually found on the dash or on the receiver itself). You'll hear a clicking sound (relay to flash the marker lights).
3. Press and release the LOCK button (only) on the first remote once.
4. Then Press and release the LOCK button (only) on the first remote a second time.

Repeat these steps 3-4 for each remote that you want to work on the system. (DO NOT PRESS ANY OTHER BUTTONS WHILE PROGRAMMING THE RECEIVER).

5. Turn the Ignition ON & OFF. You're done.

Verify that each remote has been "learned" by using all the buttons on both remotes. The New Remote's Lock & Unlock buttons will operate the entry door. The Hatch and Alarm buttons operate the Cargo Lock & Unlock respectively.

No comments:

Post a Comment

Share