Friday, February 1, 2019

2009, 2010, 2011, 2012, Lincoln Mks Keyless Remote Programming Instructions

This keyless remote programming instructions work for Lincoln MKS l,u,t,p remote with part # 164-R7032, and FCC id M3N5WY8406 on the back of it.



NOTE: A maximum of four intelligent access keys can be programmed to your vehicle. If you would like to replace a previously programmed access key with a new access key, or if you already have four access keys programmed to your vehicle, you must take your vehicle and all access keys to your authorized dealer to be erased and reprogrammed.

ADDING A SPARE INTELLIGENT ACCESS KEYS

You must have two previously programmed intelligent access keys inside the vehicle and the new un-programmed intelligent access keys readily accessible. If two previously programmed keys are not available, you must take your vehicle to your authorized dealer to have the spare key(s) programmed.

Ensure that the vehicle is off before beginning this procedure. Ensure that all doors are closed before beginning this procedure and that all doors remain close throughout the procedure. Perform this procedure exactly as described below, and perform all steps within 30 seconds of starting the sequence. If any steps are performed out of sequence, stop and wait at least one minute before starting again.

Please read and understand the entire procedure before you begin.

1. Please the new un-programmed intelligent access key in the pocket inside the center console utility compartment.
2. Press the driver or passenger power door unlock control three times.
3. Press and release the brake pedal one time.
4. Press the driver or passenger power door lock control three times.
5. Press and release the break pedal on time. The indicator on the start/stop button should begin  rapidly flash, indicating that the programming mode has been activated and two programmed intelligent keys have been detected in the vehicle.
6. Within one minute, press the start/stop button. A message will be displayed on the message center indicating that the new intelligent Access Key was programmed. If four intelligent access keys have already been programmed to your vehicle, you cannot program anymore.

MAX # OF KEYS LEARNED will be displayed on the message center.

7. Remove Intelligent Access Key from the utility compartment pocket and press the unlock or lock control on the newly programmed intelligent access keys to exit programming mode.
8. Verify that the remote entry functions operate (lock, unlock) and that the vehicle starts with the Intelligent Access Key.

If the intelligent Access Key has been successfully programmed, it can be used to activate the Intelligent Access with Push Button Start feature and can be used to start your vehicle.

No comments:

Post a Comment

Share