Wednesday, November 7, 2018

2010 Cadillac Escalade Keyless Remote Programming Instructions

This keyless remote programming instructions work for 4B (L,U,RG,P) remote with part # 22951508, 22756460, 20869054, 25830632, 15916015, 15913416, 1585783A5, FCC id OUC60270, OUC60221 on the back of it.

Replacement Remote 22951508, 22756460, 20869054, 25830632, 15916015, 15913416, 1585783A5,  OUC60270, OUC60221
Replacement Remote
NOTE: You can system can save/program up to 8 remotes in it's memory. Before
we start programming put your key in the ignition and turn it to ON position. (Don't
start the engine) so you can access the (DIC)
The figure on top will be your guide when programming the remote.
1. Press the vehicle information button until the "Press (check) to reprogram a remote" displays.
2. Press the set/reset button until the Remote Programming Active is displayed.
3. Press and hold both LOCK and UNLOCK on the remote at the same time for 15 seconds. For vehicles with the memory recall seats, first remote programmed will be driver 1 and the second will be driver 2 and so on. You'll hear a chrime which indicates the remote has been programmed.
3. Press and hold the lock and unlock buttons on the first transmitter at the same time for about 15 seconds. On vehicles with the memory recall seats, the first transmitter learned will match driver 1 and the second will match driver 2. A chime will sound indicating that the transmitter is matched.
4. If you're programming another (a maximum of 8) remote just go back to step 3. 
5. To turn the programming mode off just twist the key to Lock then back to Off position in the ignition.

No comments:

Post a Comment

Share