Saturday, November 24, 2018

2005, 2006, 2007, 2008 Subaru Forester Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U Square in half circle remote with part # 88036-FE041 FCC id NHVWB1U711 on the back of it.

Replacement Remote 88036-FE041, NHVWB1U711
Replacement Remote
1. Open the remote, locate and write down the eight digit number on the circuit board.
2. Sit in driver seat, close all doors and trunk.
3. Open and close the driver door one time. 
Within 45 seconds:
4. Open and close the door once.
5. Turn the ignition from LOCK to ON 10 times within 15 seconds. A tone will sound once and a buzzer will continue to sound. The interior light will flash until remote codes are learned.
6. Within 15 seconds open and close the driver door and an electronic tone will sound for 30 seconds.
7. Before the electronic tone stops press the power door lock button to LOCK the same number of times as the first digit of the circuit board code. Press UNLOCK to indicate you are moving to the next digit. Repeat this step for each digit. After each digit entry you must press UNLOCK within 5 seconds or the process will time  out.
8. When you finish all 8 digits, within 5 seconds press UNLOCK and repeat step 6 all over again. After the 8th digit a tone will sound for 30 seconds.
9. To add additional remotes repeat steps 5 to 8 for each remote.
10. When you are finished remove key from ignition.

No comments:

Post a Comment

Share