Tuesday, November 27, 2018

2005, 2006, 2007 Chevrolet Corvette Keyless Remote Programming Instructions

This keyless remote programming instructions work for VETTE #2 remote with part # 10372542 FCC id M3N65981403 on the back of it.

Replacement Remote 10372542, M3N65981403
Replacement Remote
NOTE: This instruction only adds remote to the system with existing ones program up to 4 remote to your
car's system. New fobs will be numbered in sequence based on when they are programmed; if 2 fobs are
currently programmed to the vehicle, a fob programmed using this method will be numbered as Fob 3.
This procedure requires that you have a known good key fob, a replacement key fob, and the vehicle's
mechanical key. If a known good key fob is not available, use the second method.

1. While the vehicle is OFF, open the rear compartment.
2. Place a known key fob within the interior of the vehicle.
3. Put the key into the ignition, located above the license plate and cycle the key 5 times within 5 seconds.
4. DIC will display: READY FOR FOB X (X=fob2,3, or 4).
5. Put the replacement remote in the glove box pocket with the button facing right.
6. A beep will occur and the DIC will display: READY FOR FOB X (X=fob 3 or 4) or MAX FOBS LEARNED.
7. To program another remote just repeat steps 4 and 5, or press the OFF/ACC portion of the ignition switch to turn programming mode OFF. Test the remote.

NOTE: These instructions will erase all saved fobs in the system's memory and program single or multiple key
fobs. This procedure requires the you have a replacement remote and the vehicle's mechanical key. The
order in which the key fobs are programmed will determine its numbering position within the vehicle's memory. The number stamped on the key fob case is reference only: 2 can be programmed as 1. Do not place any known good key fobs in the vicinity of the vehicle when programming with this method or the programming mode will resort to the ADD method above.

1. While the vehicle OFF, open the rear compartment.
2. Place the replacement remote in the glove box pocket with the buttons facing right.
3. Put key in the ignition and cycle the key 5 times within 5 seconds.
4. The DIC will display: OFF/ACC TO LEARN.
5. Press OFF/ACC portion of the ignition button.
6. The DIC will display: WAIT 10 MINUTES then it will count down from 10 tp 0, 1 minute at a time.
7. When the counter reaches 0, DIC will display OFF/ACC TO LEARN.
8. Repeat steps 5-6 two more times for a total of 30 minutes.
9. You'll hear a beep and the DIC will display: READY FOR FOB 1. At this time all previously known key fobs have been erased. When fob 1 is programmed a beep will be heard and the DIC will display: READY FOR FOB 2.
10. Another remotes can be programmed by taking the first remote out of the pocket and inserting fob 2. You can only program up to 4 remotes and if the 4th remote have been programmed, the DIC will display: MAX FOBS LEARNED, and will automatically exit programming mode.
11. If learning less than 4 key fobs, press the OFF/ACC portion of the ignition button to programming mode OFF.
12. Check all your remotes. 

No comments:

Post a Comment

Share