Monday, November 5, 2018

2004, 2005, 2006 Nissan Titan Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B L,U,P remote with part # 28268-5W50A, 28268-5W501, 28268-5W500, 28268-7Z800, 285A0-7Z800, 28268-C990A, 28268-C990C, FCC id KBRASTU15 on the back of it.

Replacement Remote 28268-5W50A, 28268-5W501, 28268-5W500, 28268-7Z800, 285A0-7Z800, 28268-C990A, 28268-C990C, KBRASTU15
Replacement Remote
NOTE: Once you placed your receiver on programming mode it's memory will reset. So, make sure to
reprogram your existing remote if you are to use them as well.

1. Close and lock all doors with the driver’s side power lock/unlock switch.
2. Put the key in the ignition and remove it from the ignition key cylinder at least six times within 10 seconds.
Your Hazard Lamps will flash if you do this step successfully. System will not enter programming mode if you
do this step too fast.
3. Insert key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.
5. To program your old remote, unlock and lock all doors using the driver’s side power lock/unlock switch and
within 5 seconds, push ANY button on the remote. Your Hazard Lamps should flash. Repeat this step for each
you will be programming.
6. Twist the key to the OFF position, remove it from the ignition, unlock doors using the driver’s side power
lock/unlock switch and open the driver side door. And you're done.

No comments:

Post a Comment

Share