Sunday, November 18, 2018

2003, 2004, 2005 Mitsubishi Eclipse Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U,P remote with part # MR587982, FCC id OUCG8D-525M-A, and part # G8D-525M-A on the back of it.

Replacement Remote MR587982, OUCG8D-525M-A, G8D-525M-A
Replacement Remote
1. Locate the Data Line Connector (DLC) underneath the driver’s side dashboard. The DLC is typically located either to the left or the right of the steering column base. Use the figure to the side as a map for your DLC (they usually aren’t numbered). The view in figure b, is looking straight into the cavities of the DLC. Notice
how the DLC is tapered on both ends: we will be working on the wider row of cavities (1 through 8 in figure b.).
2. Insert keys in ignition and leave in the OFF position.
3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Line Connector (DLC) terminal 1 to terminal 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 1 and 4.
4. In 10 seconds, press the Hazard Switch 6 times. The door locks should cycle (lock and unlock) which means you're now in programming mode.
5. Press Lock or Unlock button 3 times within 10 seconds. Door locks will cycle which means the remote has been successfully programmed.
6. If there is a second transmitter, press the LOCK or UNLOCK button three times within one minute and the
doors will lock and unlock once to confirm successful programming.
7. Disconnect the programming wire and remove the keys from the ignition.


No comments:

Post a Comment

Share