Tuesday, November 13, 2018

2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010 Lincoln Navigator Keyless Remote Programming Instructions

This keyless remote programming instructions work for new 4B cars remote with part # 8S4Z-15K601-A, 8S4T-15K601-AA, 2S4T-15K601-AB, 2S4Z-15K601-AA, FCC id CWTWB1U345, and CWTWB1U331 on the back of it.

Replacement Remote 8S4Z-15K601-A, 8S4T-15K601-AA, 2S4T-15K601-AB, 2S4Z-15K601-AA, CWTWB1U345, CWTWB1U331
Replacement Remote
1. Insert the keys in the ignition and turn the ignition switch from OFF to RUN, up to eight times within ten seconds, ending in OFF. When the vehicle has successfully entered programming mode, it will lock and then unlock all door locks automatically.
(Note: In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing this step you should open the driver door and cycle the power door locks twice. This means you press LOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eight times then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. In 10 seconds, press any button on the first remote you're programming. Door locks will cycle if the remote has been successfully programmed.
3. Repeat step 2 to program another remote including the existing/old ones.
4. If you didn't get any indication that the remote has been programmed, wait 10 seconds and press any button again. 
5. After programming the remotes ofcourse you will need to exit programming mode. To do that,you will need to twist the key in the ignition to OFF or wait up to 30 seconds for the system to turn program mode itself.

No comments:

Post a Comment

Share