Wednesday, November 14, 2018

2001 Chrysler Lhs Keyless Remote Programming Instructions

This keyless remote programming instructions work for  remote with part # 04602260AA, AD, FCC id GQ43VT17T on the back of it.

Replacement Remote 04602260AA, AD, GQ43VT17T
Replacement Remote
1. Press the [LOCK] button 5 times on any working  (programmed) transmitter at 2 second intervals to
resynchronize transmitter.
2. Turn ignition to the RUN position (as far as you can go without cranking the engine). Wait for chimes to stop.
3. Using the working (programmed) transmitter, press and hold the UNLOCK button on the transmitter for
between 4 and 10 seconds.
4. Within the specified 4 to 10 seconds, continue pressing the UNLOCK button and press the PANIC button (on the existing programmed remote) for 1 second and release both buttons. A chime will sound to indicate that the transmitter programming mode has been entered (allow 3 seconds for chime to sound).
5. Within 30 seconds of the chime, press and release the LOCK and UNLOCK buttons simultaneously then press and release just the UNLOCK button on the SAME transmitter. A chime will sound indicating the transmitter has been re- programmed. Repeat this step (press and release the LOCK and UNLOCK buttons
simultaneously then press and release just the UNLOCK button) for each new transmitter you wish to program. A chime will sound after each additional transmitter is programmed.
6. Turn the ignition OFF and remove the keys to exit the transmitter programming mode.
7. Test each transmitter for function.

Troubleshooting: If, at the “press and release just the UNLOCK button” in the second line at step 5, the door locks unlock instead of give you a chime then you need to reverse steps 1 and 2.

No comments:

Post a Comment

Share