Tuesday, November 20, 2018

2000, 2001, 2002, 2003, 2004 Mitsubishi Montero Sport Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U Australian Pajero remote with part # MR587978, FCC id E4EG8D-522M-A, G8D-523M-A on the back of it.

Replacement Remote MR587978, E4EG8D-522M-A, G8D-523M-A
Replacement Remote
1. Locate the Data Line Connector (DLC) underneath the driver’s side dashboard. The DLC is typically
located either to the left or the right of the steering column base. Use the figure to the side as a map for your DLC (they usually aren’t numbered). The view in figure b, is looking straight into the cavities of the DLC. Notice how the DLC is tapered on both ends: we will be working on the wider row of cavities (1 through 8 in figure b.).
2. Insert keys in ignition and leave in the OFF position (all doors must be closed.)
3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Line Connector (DLC) terminal 1 to terminal 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 1 and 4.
4. Within 10 seconds after connecting the jumper wire, turn the ignition switch to the ACC position and then back to OFF (do this as quick as you can!). Repeat this procedure two more times (very quickly! – you should be able to get the three ACC to OFF cycles in less than 2 seconds). NOTE: The doors will automatically lock and unlock once indicating that the system is in the programming mode.
5. Press either the LOCK or UNLOCK button on the transmitter to be registered three times within 10 seconds. Upon successful programming, the door will lock and unlock once.
6. If there is a second transmitter, press the LOCK or UNLOCK button three times within one minute and the doors will lock and unlock once to confirm successful programming.
7. Disconnect the programming wire and remove the keys from the ignition.

No comments:

Post a Comment

Share