Saturday, November 10, 2018

1999, 2000 Pontiac Montana Keyless Remote Programming Instructions

This keyless remote programming instructions work for l,u,psd remote with part # 10245951, FCC id ABO0204T on the back of it.

Replacement Remote 10245951, ABO0204T
Replacement Remote
NOTE: When your system has successfully programmed a new remote, it will automatically delete all existing remote's codes from it's memory. Just reprogram them by following step 7.

1. Make sure your key is not in the ignition.
2. Remove the “BCM PRGRM” fuse from the fuse panel, you'll find it by opening the front passenger door. Use the legend on the fuse panel to look for the “BCMPRGRM” fuse.
3. Close all the doors of the vehicle then close the lifgate.
4. Put the key in the ignition and turn to ACC (Do not start the engine).
5. Turn the ignition OFF and back to ACC. (Fast)
6. Open and close any door. You'll hear a chime when the system enters programming mode.
7. Press and hold LOCK and UNLOCK buttons on your remote at the same time for 14 seconds. After 7 seconds, you'll hear a chime which indicates the remote has been successfully programmed. Then wait approximately 14 seconds for another chime.
8. Repeat step 8 to program another remote.
9. Take the key off from the ignition.
10. Put the “BCM PRGRM” fuse back.

No comments:

Post a Comment

Share