Monday, November 19, 2018

1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006 Mitsubishi Montero Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U,P remote with part # MR587977, FCC id E4EG8D-522M-A, G8D-522M-A on the back of it.

Replacement Remote MR587977, E4EG8D-522M-A, G8D-522M-A
Replacement Remote
1. Locate the Data Line Connector (DLC) underneath the driver’s side dashboard. The DLC is typically located either to the left or the right of the steering column base. Use the figure to the side as a map for your DLC (they usually aren’t numbered). The view in figure b, is looking straight into the cavities of the DLC. Notice
how the DLC is tapered on both ends: we will be working on the wider row of cavities (1 through 8 in figure b.).
2. Insert keys in ignition and leave in the OFF position.
3. Make sure there are metal contact pins in terminals 1 and 4 and connect the Data Line Connector (DLC) terminal 1 to terminal 4 with a suitable jumper wire (leave the jumper wire connected throughout the
programming procedure). Make sure you know which terminals are 1 and 4.
4. Press the Hazard Switch 6 times within 10 seconds. The door locks will cycle (lock and unlock) which means you've activated the programming mode.
5. Within 10 seconds, press Lock and Unlock buttons on the remote. You'll get another door lock cycle which means the remote has been programmed.
6. If you want to program another remote just press Lock or Unlock button 3 times within 1 minute. Door locks will cycle indicating it's been programmed.
7. Take the jumper wire the terminals and the key from the ignition to exit from programming mode.


No comments:

Post a Comment

Share