Tuesday, November 13, 2018

1998, 1999, 2000, 2001 Lincoln Navigator Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 8L3Z-15K601-B, 8L3Z-15K601-AA, 8L3T-15K601-AA, F8DB-15K601-AA, 2L3T-15K601-AA, 2L3T-15K601-AB, FCC id CWTWB1U345, and CWTWB1U331 on the back of it.

Replacement Remote
NOTE: Other Remotes that was programmed to the system will be delete from it's memory after programming a new one. So, if you want to continue using them follow the steps below to reprogram the existing/old ones.

1. Put the keys in the ignition and turn OFF to RUN 8 times within 10 seconds, ending in OFF position. Door locks will cycle (lock then unlock) once it has entered programming mode.
(Note: The RUN position is as far as you can turn the key without cranking the engine. If the door locks do not cycle indicating programming mode has been entered, try the procedure without doing step 1 and having the driver door closed. If you still can’t get into programming mode after trying this numerous times both ways then you either do not have the factory keyless entry system or it is not functioning properly. In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing this step you should open the driver door and cycle the power door locks twice. This means you pressLOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eighttimes then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. Within 15 seconds, press ANY button on a keyless entry remote transmitter. The doors will lock and then unlock to confirm that each keyless entry remote transmitter has been activated.
(Note: When the first keyless entry remote transmitter is programmed, all existing keyless entry remote transmitters are erased.)
3. Repeat step 2 immediately for each transmitter that will operate the vehicle including your old ones (if any.)
4. If the door locks did not cycle, wait 10 seconds and press any button again.
5. To exit the system from programming mode just turn the key in the ignition to OFF position or wait up to 30 seconds after step 2.

No comments:

Post a Comment

Share