Wednesday, November 7, 2018

1995 Gmc Jimmy Keyless Remote Programming Instructions

This keyless remote programming instructions work for (2060) 3B remote with part # 15692636, 15955515, 15955516, 25609144, 25555951, 15692336, 10239647, 25559364, 25609144, 15657587, 15955702, 15725423 new, 15731442, FCC id ABO0103T, ABO0104T on the back of it.

Replacement Remote 15692636, 15955515, 15955516, 25609144, 25555951, 15692336, 10239647, 25559364, 25609144, 15657587, 15955702, 15725423, 15731442, ABO0103T, ABO0104T
Replacement Remote
Replacement Remote 15692636, 15955515, 15955516, 25609144, 25555951, 15692336, 10239647, 25559364, 25609144, 15657587, 15955702, 15725423, 15731442, ABO0103T, ABO0104T
Replacement Remote
1. Locate the programming connector under driver side dash near the remote Keyless Entry module. You will need to remove the lower driver side dash trim to access the connector. It is a RED connector with two wires and may be tapped to the wiring harness that ultimately leads up to the keyless entry module.
2. Short the programming connector terminals together with suitable jumper wire.Receiver will respond by locking and unlocking doors within 2 seconds.

3. Press any button of the first transmitter to be programmed. The control module will respond by locking/unlocking doors and activating rear window release.
4. Press any button of the second transmitter to be programmed (including old ones, if used). The control module will respond by locking/unlocking door and activating the rear window release.

5. Remove the jumper wire applied to the reprogramming connector.

No comments:

Post a Comment

Share