Monday, November 12, 2018

1993, 1994, 1995, 1996, 1997 Mercury Sable Keyless Remote Programming Instructions

This keyless remote programming instructions work for 4B remote with part # 3165189, F5DZ-15K601-B, FCC id GQ43VT4T on the back of it.

Replacement Remote 3165189, F5DZ-15K601-B, GQ43VT4T
Replacement Remote
1. Insert the keys in the ignition and turn the ignition switch from OFF to RUN, up to eight times within ten seconds, ending in OFF. When the vehicle has successfully entered programming mode, it will lock and then unlock all door locks automatically.
(Note: The RUN position is as far as you can turn the key without cranking the engine. If the door locks do not cycle indicating programming mode has been entered, try the procedure without doing step 1 and having the driver door closed. If you still can’t get into programming mode after trying this numerous times both ways then you either do not have the factory keyless entry system or it is not functioning properly. In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing
this step you should open the driver door and cycle the power door locks twice. This means you press LOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eight times then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. Within 15 seconds, press ANY button on a keyless entry remote transmitter. The doors will lock and then
unlock to confirm that each keyless entry remote transmitter has been activated.
(Note: When the first keyless entry remote transmitter is programmed, all existing keyless entry remote transmitters are erased.)
3. Repeat step 2 immediately for each transmitter that will operate the vehicle including your old ones (if any.)
4. If you didn't get any indication that the remote has been programmed, wait 10 seconds and press any button again.
5. After programming the remotes ofcourse you will need to exit programming mode. To do that, you will need to twist the key in the ignition to OFF or wait up to 30 seconds for the system to turn program mode itself.

No comments:

Post a Comment

Share