Sunday, November 4, 2018

1990, 1991 Oldsmobile 98 Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, FCC id ABO0103T, GQ43VT1, ABO0104T, ABO0116T on the back of it.

Replacement Remote 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, ABO0103T, GQ43VT1, ABO0104T, ABO0116T
Replacement Remote
1. Make sure ignition is in the OFF position.
2. Locate the programming connector behind the passenger side instrument panel (accessed by opening the glove box and looking to the top left side, where it is held in place by a clip). It is a plastic connector with two wires leading up to it. The connector is not plugged into anything. You will have to pull out the inner tray of
the glove compartment to access the connector.
3. The programming connector has two terminals. Connect both terminals with a suitable jumper wire. The keyless entry module will cycle the door lock motors once. Make sure the jumper wire remains connected throughout the procedure.
4. Press the unlock button on the first remote. In response the keyless entry module will cycle the door lock motors again.
5. If a second remote is to be programmed (including your old one), press the unlock button on the second remote. Door locks cycle again.
6. Remove jumper wire.

No comments:

Post a Comment

Share