Thursday, October 4, 2018

2001, 2002, 2003, 2004, 2005 Chevrolet Venture Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B L,U, PSD remote with part # 10335584, 10335582-88, OR 9364556-4575, FCC id L2C0007T on the back of it.

Replacement Remote 10335584, 10335582-88, 9364556-4575, L2C0007T
Replacement Remote
NOTE: When your system has successfully programmed a new remote, it will automatically delete all existing remote's codes from it's memory. Just reprogram them by following step 7.

1. Make sure your key is not in the ignition.
2. Remove the “BCM PRGRM” fuse from the fuse panel, you'll find it by opening the front passenger door. Use the legend on the fuse panel to look for the “BCMPRGRM” fuse.
3. Close all of the doors.
4. Close the liftgate.
5. Insert keys into the ignition, and turn the ignition lock cylinder to ACC (one click towards you – the opposite direction from starting the engine).
6. Turn the ignition to OFF, and then quickly back to ACC.
7. Open and close any door. You'll hear a chime when the system enters programming mode.
8. Press and hold the LOCK and UNLOCK buttons on the remote at the same time for 14 seconds. IMPORTANT: After 7 seconds, you'll hear a chimme which indicates the remote has been successfully programmed. Then wait approximately 14 seconds for another chime. Your new remote has been programmed but all existing remote codes have been erased.
9. Go back to step 8 for programming another remote.
10. Remove key.
11. Put the “BCM PRGRM” fuse back into the fuse panel.

No comments:

Post a Comment

Share