Monday, October 1, 2018

1997 Oldsmobile Bravada Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 16245103trunk, 16245105rear2x, 16245100-29, 16207901-5, FCC id AB01502T on the back of it.

Replacement Remote 16245103, 16245105, 16245100-29, AB01502T
Replacement Remote
Follow steps below:

Programming a new remote to the system will erase previously programmed remotes from it's memory. So, make sure to reprogram your existing remotes after the new one.

1. Put the key in the ignition. (Don't turn it)
2. Look for the Data Line Connector (DLC) underneath the driver's side dasboard. Use the figures below as a map for your DLC (they usually aren't numbered) based on how your DLC is positioned. The view in the picture below is looking straight into the cavities of the DLC. Notice how the DLC is tapered on both ends: We will be working on the wider row of cavities (1 through 8 in the figure below).

3. Make sure there are metal contact pins in terminals 8 and 4 and connect the Data Line Connector (DLC) terminal 8 to terminal 4 with suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond by cycling the locks (locking then unlocking doors) to signify entering of programming mode.
4. Press and hold both LOCK and UNLOCK buttons together on the first transmitter to be programmed. After about 30 seconds, the vehicle will respond by cycling the locks (locking then unlocking doors). Release the buttons on the transmitter.

5. To program another remote just go back to step 4.
6. Remove the jumper wire from the DLC (disconnect terminals 8 and 4).
7. Test the remotes.


No comments:

Post a Comment

Share