Saturday, October 13, 2018

1997, 1998, 1999 Chevrolet Malibu Keyless Remote Programming Instructions

 This keyless remote programming instructions work for 3B remote with part # 16245103, trunk 16245105, rear2x 16245100-29, 16207901-5, FCC id AB01502T on the back of it.

Replacement Remote 16245103, 16245105, 16245100-29, 16207901-5, AB01502T
Replacement Remote
1. Make sure ignition is in the OFF position.
2. Locate the Programming Connector in the trunk (center of rear shelf). It is a plastic connector with two wires leading up to it. The connector is not plugged into  anything. You may have to pull back trim to access the connector.
3. The programming connector should have two terminals. Connect both terminals with a suitable jumper wire. The Keyless Entry Module will lock then unlock all the door lock motors once. Make sure the terminals remain connected throughout the programming procedure.
4. Press and hold the LOCK and UNLOCK buttons on the transmitter simultaneously for at least 15 seconds or until the vehicle automatically locks and unlocks the door locks. Your new remote has been accepted and all existing remote codes have been erased.
5. Repeat the previous step for each transmitter to be programmed. Do not remove jumper wire in between programming of transmitters.
6. Remove the jumper wire from the Keyless Programming Connector.


No comments:

Post a Comment

Share