Tuesday, October 30, 2018

1997, 1998, 1999 Chevrolet Cavalier Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 16245103, trunk 16245105, rear2x 16245100-29, 16207901-5, FCC id AB01502T on the back of it.

Replacement Remote 16245103, 16245105, 16245100-29, 16207901-5, AB01502T
Replacement Remote
1. Make sure the ignition is in the OFF position.
2. Locate the programming connector in the drivers side trunk. It is a plastic connector with 2 wires leading to it. It is not plugged into anything.
3. The Connector has two terminals. Connect the terminals with a suitable jumper wire. The locks will cycle to confirm programming mode. Keep the jumper wire connected.
4. Press and hold LOCK and UNLOCK buttons on the remote for 10 seconds or until the door locks cycle. Your new remote has been programmed and existing ones are erased from the system's memory.
5. Repeat the previous step for every remote (including old ones).
6. Remove jumper wire.


No comments:

Post a Comment

Share