Sunday, October 28, 2018

1997, 1998 Buick Skylark Keyless Remote Programming Instructions

This keyless remote programming instructions work for 4B remote with part # 16245100rear2x, 16245104trunk, 16245100-29, 16207901-5 FCC id AB01502T  on the back of it.

Replacement Remote 16245100rear2x, 16245104trunk, 16245100-29, 16207901-5
Replacement Remote
1. Make sure the ignition is in the OFF position.
2. Locate the programming connector in the drivers side trunk. It is a plastic connector with 2 wires leading to it. It is not plugged into anything.
3. The programming connector has two terminals. Connect the terminals with a suitable jumper wire. The locks will cycle to confirm programming mode. Keep the jumper wire connected.
4. Press the LOCK and UNLOCK buttons on the remote simultaneously (for up to 30 seconds.) The door locks will cycle to confirm the remote has been learned. Release the buttons. Your new remote has been programmed and all previous remotes have been erased.
5. Repeat the previous step for every remote (including old ones).
6. Remove jumper wire.

No comments:

Post a Comment

Share