Monday, October 1, 2018

1996, 1997, 1998, 1999 Oldsmobile Aurora Keyless Remote Programming Instructions

This keyless remote programming instructions work for used to be 2070, 2220, 2221, 2230, 2231, 2240 remote with part # 15732805, 25656444, 25656445, 25665574, 25665575, 25628814, 25668603, 25678792 FCC id KOBUT1BT and part # D board on the back of it.

Replacement Remote 15732805, 25656444, 25656445, 25665574, 25665575, 25628814, 25668603, 25678792, KOBUT1BT
Replacement Remote
CAUTION: Programming a new remote to the system will erase previously programmed remotes from it's memory. So, make sure to reprogram your existing remotes after the new one.

1. Put the key in the ignition. (Don't turn it)
2. Look for the Data Line Connector (DLC) underneath the driver's side dasboard. Use the figures below as a map for your DLC (they usually aren't numbered) based on how your DLC is positioned. The view in the picture below is looking straight into the cavities of the DLC. Notice how the DLC is tapered on both ends: We will be working on the wider row of cavities (1 through 8 in the figure below).
3. Check if there are metal contact pins in terminals 8 and 4 and connect the Data Line Connector (DLC) terminal
8 to terminal 4 using a jumper wire. Door locks will cycle which means you're now in programming mode.
4. Press and hold LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle (Lock and Unlock). Then release the buttons.
5. Within one minute, repeat step 4 on the remaining transmitters to be programmed.
6. Remove the jumper wire applied to the DLC (disconnect terminals 8 and 4).
7. test transmitter(s) for function.


No comments:

Post a Comment

Share