Friday, October 12, 2018

1996, 1997, 1998, 1999 Infiniti l30 Keyless Remote Programming Instructions

This keyless remote programming instructions work for INFINITI LOGO remote with part # 28268-40U15, FCC id A269ZUA078 on the back of it.

Replacement Remote 28268-40U15, A269ZUA078
Replacement Remote
NOTE: Once you placed your receiver on programming mode it's memory will reset. So, make sure to reprogram your existing remote if you are to use them as well. 

1. Close and lock all doors with the driver’s side power lock/unlock switch.
2. Put the key in the ignition and remove it from the ignition key cylinder at least six times within 10 seconds.
Your Hazard Lamps will flash if you do this step successfully. System will not enter programming mode if you
do this step too fast.
3. Put key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote ONCE. Your Hazard Lamps should flash. Indicating the
remote and system is paired.
5. To program your old remote, unlock and lock all doors using the driver’s side power lock/unlock switch and
within 5 seconds, push ANY button on the remote. Your Hazard Lamps should flash. Repeat this step for each
you will be programming.
6. Turn the key to the OFF position, remove it from the ignition, unlock doors using the driver’s side power
lock/unlock switch and open the driver side door. And you're done.

No comments:

Post a Comment

Share