Sunday, October 14, 2018

1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996 Buick Regal Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, FCC id ABO0103T, GQ43VT1, ABO0104T, ABO0116T on the back of it.

Replacement Remote 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738,  ABO0103T, GQ43VT1, ABO0104T, ABO0116T
Replacement Remote
ATTENTION: Programming a new remote will delete your existing remote codes from the system's memory. REprogram them after the new one.

1. Find the Programming Connector in the passenger side trunk. It's a plastic connector with one wire leading to it. You may also have to pull the back the trim to access the connector.
2. The programming connector should have one terminal. Ground this terminal to the trunk hatch or antenna. Door locks should cycle (lock and unlock) indicating your system is in programming mode. Do not remote the ground wire until step 5.
3. Press any button on the remote. The Door locks should cycle which means your remote has been programmed.
4. To add more remotes or reprogram your existing ones just press any buttons on it. And if the door locks will cycle, this means the remote has been programmed.
5. To turn programming mode OFF just Remove the ground from the programming terminal.

No comments:

Post a Comment

Share