Friday, October 26, 2018

1993, 1994, 1995, 1996 Buick Roadmaster Estate Wagon Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, FCC id ABO0103T, GQ43VT1, ABO0104T, ABO0116T on the back of it.

Replacement Remote 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, ABO0103T, GQ43VT1, ABO0104T, ABO0116T
Replacement Remote
1. Remove driver’s side back body pillar finish panel to access programming connector. It’s in the rear compartment between tail-light and wheel well.
2. Ground the programming connector to a suitable location. The door lock assemblies and rear compartment lid lock assembly or end gate window solenoids will cycle indicating receiver assembly is in program mode.
No liabilities for any use of the programming instructions and/or telephone guidance are assumed whatsoever for any costs, claims or damages filed for or caused by correct or incorrect use of the information provided for programming. Remotesandkeys cannot and is not responsible for any type of damage, intentional or otherwise, caused by the use of the programming instructions and guidance. Remotesandkeys is not responsible for any type of harm, whether physical or otherwise, due to correct or incorrect use of the procedures or techniques provided for programming.
3. Press any button (only once) on transmitter. The door lock assemblies and rear compartment lid lock assembly or end gate window solenoids will cycle once confirming that transmitter code is programmed. Any transmitter code that was previously programmed has been erased. Receiver assembly is now programmed to
the transmitter assembly.
4. If programming a second transmitter (including your old one) press any button (only once) on the second transmitter. This must be done before program connector is disconnected. The door lock assemblies and rear compartment lid lock assembly or end gate window solenoids will cycle once confirming that second transmitter is programmed.
5. Disconnect the programming connector.
6. Test transmitters for function.

No comments:

Post a Comment

Share