Tuesday, October 9, 2018

1991, 1992 Chevrolet Caprice Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, FCC id ABO0103T, GQ43VT1, ABO0104T, ABO0116T on the back of it.

Replacement Remote 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, ABO0103T, GQ43VT1, ABO0104T, ABO0116T
Replacement Remote
1. Locate the programming connector in the driver’s side of the trunk. It is a plastic connector with two wires leading up to it. It is not plugged into anything. You may have to pull back the trim to access the connector.
2. The programming connector should have 2 terminals. Connect both terminals with a suitable jumper wire.
The locks will cycle to confirm entering programming mode. Make sure the terminals remain connected throughout the procedure.
3. Press any button on the remote once. Door locks will cycle to confirm.
4. If a second remote is to be programmed press any button on that remote. Door locks will cycle to confirm.
5. Remove the jumper wire from the programming connector.

No comments:

Post a Comment

Share