Sunday, October 14, 2018

1989, 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997 Oldsmobile Cutlass Supreme Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, and FCC id ABO0103T, GQ43VT1, ABO0104T, ABO0116T, and part # 218 K1200 on the back of it.

Replacement Remote 88959920, 10205241, 10205239, 10205240, 12522338, 10063533, 10205239, 12522337, 12522339, 12522356, 10097895, 10097894, 10205674, 10092854, 10097894, 10063534, 10178738, ABO0103T, GQ43VT1, ABO0104T, ABO0116T
Replacement Remote
Perform steps below to program the remote:

1. Locate the Programming Connector in the passenger side trunk. It is a plastic connector with one wire leading to it. It is not plugged into anything. You may have to pull back the trim to access the connector.
2. The programming connector should have one terminal. Ground this terminal to the trunk hatch or antenna. The door locks will cycle (lock and unlock by themselves) to indicate that programming mode has begun. Make sure the programming connector stays grounded throughout the procedure.
3. Press any button on the remote. Door locks should cycle which means the remote has been successfully programmed.
4. Tp program another remote just press any buttons on it. Then the door locks will cycle to indicate it has been programmed.
5. To exit programming mode just Remove the ground of programming terminal.

No comments:

Post a Comment

Share