Wednesday, September 26, 2018

2009, 2010 Chevrolet Traverse Keyless Remote Programming Instructions

This keyless remote programming instructions work for 5B (RS,L,U,RG,P) remote with part # 1591341515857839, 25839476, 15916016, 20869963, 20869053, 20952477, 22756459 FCC id OUC60270, OUC60221, and part # 22936101, 22951509, 20952476 on the back of it.

Replacement Remote 15913415, 15857839, 25839476, 15916016, 20869963, 20869053, 20952477, 22756459, OUC60270, OUC60221, 22936101, 22951509, 20952476
Replacement Remote
If you have DIC buttons: Insert the ignition key and turn to the ON position (position just before you crank the vehicle) so you can access the (DIC). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle. To match an RKE transmitter to your vehicle:

1. Press the vehicle information button until PRESS TO RELEARN REMOTE KEY displays.
2. Press the set/reset button until REMOTE KEY LEARNING ACTIVE is displayed.
3. Press and hold the lock and unlock buttons on the first transmitter at the same time for about 15 seconds. On vehicles with memory recall seats, the first transmitter learned will match driver 1 and the second will match driver 2. A chime will sound indicating that the transmitter is matched.

4. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of eight transmitters matched to it.
5. To exit the programming mode, you must cycle the key to LOCK/OFF.

If you don’t have DIC buttons:  To access this display, the vehicle must be in PARK (P). This display allows you to match Remote Keyless  Entry (RKE) transmitters to your vehicle. To match an RKE transmitter to your vehicle: 

1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY  LEARNING ACTIVE will display.

3. Press and hold the lock and unlock buttons on the first transmitter at the same time for about 15  seconds. On vehicles with memory recall seats, the first transmitter learned will match driver 1 and the second will match driver 2. A chime will sound indicating that the transmitter is matched.
4. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of  eight transmitters matched to it.
5. To exit the programming mode, you must cycle the key to LOCK/OFF.

No comments:

Post a Comment

Share