Wednesday, September 26, 2018

2009, 2010 Chevrolet Traverse Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U,P remote with part # 15913420, 20952475 20869056, 22936099, FCC id OUC60270, OUC60221 on the back of it.

Replacement Remote 20868672,  20952474, 15913421, 20868672, 22759546, 22936098, 25771045, 15857837, OUC60270
Replacement Remote
If you have DIC buttons:
Insert the ignition key and turn to the ON position (position just before you crank the vehicle) so you can access the (DIC). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle. To match an RKE transmitter to your vehicle:

1. Press the vehicle information button until the PRESS TO REPROGRAM REMOTE message displays.
2. Press the set/reset button until REMOTE PROGRAMMING ACTIVE is displayed.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall seats, the first remote programmed will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote has been programmed.

4. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of eight transmitters matched to it.
5. To exit the programming mode, you must cycle the key to LOCK/OFF.

For cars without DIC buttons:
To access this display, the vehicle must be in PARK (P). This display allows you to match Remote Keyless
Entry (RKE) transmitters to your vehicle.

To program the remote to your vehicle just do the steps below:

1. Press the trip odometer reset stem until REPROGRAM REMOTE displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY PROGRAMMING ACTIVE will display.

3. Press and hold the lock and unlock buttons on the first transmitter at the same time for about 15 seconds. On vehicles with memory recall seats, the first transmitter learned will match driver 1 and the second will match driver 2. A chime will sound indicating that the transmitter is matched.
4. To match additional transmitters at this time, repeat Step 3. Each vehicle can have a maximum of eight transmitters matched to it.
5. To exit the programming mode, you must cycle the key to LOCK/OFF.

No comments:

Post a Comment

Share