Wednesday, September 26, 2018

2008, 2009, 2010 Buick Enclave Keyless Remote Programming Instructions

This keyless remote programming instructions work for RS,L,U,P remote with part # 20868672, 20952474, 15913421, 20868672, 22759546, 22936098, 25771045, 15857837, FCC id OUC60270, on the back of it.

Replacement Remote20868672, 20952474, 15913421 20868672, 22759546, 22936098 25771045, 15857837, OUC60270
Replacement Remote
NOTE: This instruction works on vehicles with DIC buttons only: Put your key in the the ignition and turn it to the ON position (dont start the engine) so you can access the (DIC). This display allows you to program the remote to your system.

Perform the steps below to program the remote to your system:

1. Press the vehicle information button until the PRESS TO REPROGRAM REMOTE message shows up.
2. Press the set/reset button until REMOTE PROGRAMMING ACTIVE is displayed.
3. Press and hold lock and unlock buttons on your remote for about 15 seconds. On vehicles with memory recall seats, the first
remote programmed will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote's code
has been programmed.

4. Go back to Step 3 to program another remote. Each vehicle can program up to 8 remotes in it's system's memory.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.

NOTE: This instruction works on vehicles without DIC buttons: To access this display, the vehicle must be in PARK (P). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle.

To program the remote to your vehicle just do the steps below:

1. Press the trip odometer reset stem until REPROGRAM REMOTE displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY PROGRAMMING ACTIVE will  
display.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall
seats, the first programmed remote will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote is programmed.
4. To program another remote (a maximum of 8), Just repeat Step 3.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.

No comments:

Post a Comment

Share