Thursday, September 27, 2018

2007, 2008, 2009, 2010 Saturn Outlook Keyless Remote Programming Instructions

This keyless remote programming instructions work for RS,L,U,P remote with part # 20868672, 20952474, 15913421, 20868672, 22759546, 22936098, 25771045, 15857837, and FCC id OUC60270 on the back of it.

Replacement Remote 20868672, 20952474, 15913421, 20868672, 22759546, 22936098, 25771045, 15857837, OUC60270
Replacement Remote
If you have DIC buttons:
Insert the ignition key and turn to the ON position (position just before you crank the vehicle) so you can access the (DIC). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle. 

To match an RKE transmitter to your vehicle:
1. Press the vehicle information button until the PRESS TO REPROGRAM REMOTE message shows up.
2. Press the set/reset button until REMOTE PROGRAMMING ACTIVE is displayed.
3. Press and hold lock and unlock buttons on your remote for about 15 seconds. On vehicles with memory recall seats, the first remote programmed will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote's code has been programmed.
4. To program another remote at this time, go back to Step 3. Each vehicle can program up to 8 remotes in it's system's memory.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.
If you don’t have DIC buttons:
To access this display, the vehicle must be in PARK (P). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle. To match an RKE transmitter to your vehicle:
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY LEARNING ACTIVE will display.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall seats, the first programmed remote will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote is programmed.
4. To program another remote (a maximum of 8), Just repeat Step 3.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.

No comments:

Post a Comment

Share