Thursday, September 27, 2018

2007, 2008, 2009, 2010 Gmc Acadia Keyless Remote Programming Instructions

This keyless remote programming instructions work for 5B (RS,L,U,RG,P) remote with part # 15913415, 1585783925839476, 15916016, 20869963, 20869053, 20952477, 22756459 FCC id OUC60270OUC60221 and part # 229361012295150920952476 on the back of it.

Replacement Remote 15913415, 15857839, 25839476, 15916016, 20869963, 20869053, 20952477, 22756459, OUC60270,  OUC60221, 22936101, 22951509, 20952476
Replacement Remote
Programming instructions for vehicles with DIC buttons: Put the key in the the ignition and turn it to the ON position (dont start the engine) so you can access the (DIC). This display allows you to program the remote to your system.

To Program the remote just follow these steps:
1. Press the vehicle information button until the PRESS TO REPROGRAM REMOTE message displays.
2. Press the set/reset button until REMOTE PROGRAMMING ACTIVE is displayed.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall seats, the first remote programmed will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote has been programmed.
4. To program another remote at this time, go back to Step 3. Each vehicle can program up to 8 remotes in it's system's memory.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.
For cars without DIC buttons: To access this display, the vehicle must be in PARK (P). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle.

To program the remote to your vehicle just do the steps below:

1. Press the trip odometer reset stem until REPROGRAM REMOTE displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY PROGRAMMING ACTIVE will display.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall seats, the first programmed remote will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote is programmed.
4. To program another remote (a maximum of 8), Just repeat Step 3.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.

No comments:

Post a Comment

Share