Wednesday, September 26, 2018

2007, 2008, 2009, 2010 Chevrolet Silverado Keyless Remote Programming Instructions

This keyless remote programming instructions work for L,U,P remote with part # 15913420, 20952475, 20869056, 22936099, FCC id OUC60270, OUC60221 on the back of it.

Replacement Remote 15913420, 20952475, 20869056, 22936099, OUC60270, OUC60221
Replacement Remote
If you have DIC buttons:
Insert the ignition key and turn to the ON position (position just before you crank the vehicle) so you can access the (DIC). This display allows you to match Remote Keyless Entry (RKE) transmitters to your vehicle. 

To match an RKE transmitter to your vehicle:
1. Press the vehicle information button until the PRESS TO REPROGRAM REMOTE message displays.
2. Press the set/reset button until REMOTE PROGRAMMING ACTIVE is displayed.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall seats, the first remote programmed will match driver 1 and the second will match driver 2. A chime will sound indicating that the remote has been programmed.
4. Go back to Step 3 to program another remote. Each vehicle can program up to 8 remotes in it's system's memory.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.
If you don’t have DIC buttons:
To access this display, the vehicle must be in PARK (P). This display allows you to match Remote Keyless
Entry (RKE) transmitters to your vehicle.

To match an RKE transmitter to your vehicle:
1. Press the trip odometer reset stem until RELEARN REMOTE KEY displays.
2. Press and hold the trip odometer reset stem for three seconds. The message REMOTE KEY
LEARNING ACTIVE will display.
3. Press and hold lock and unlock buttons on the remote at the same time for about 15 seconds. On vehicles with memory recall
seats, the first programmed remote will match driver 1 and the second will match driver 2. A chime will sound indicating that the
remote is programmed.
4. To program another remote (a maximum of 8), Just repeat Step 3.
5. Cycle the key to LOCK/OFF to turn programming mode OFF.

No comments:

Post a Comment

Share