Tuesday, September 25, 2018

2006, 2007, 2008, 2009, 2010 Toyota Rav-4 Keyless Remote Programming Instructions

This keyless remote programming  instruction works on this 3B remote with part # 89070-42540, 89070-42660, 89070-42670 and FCC id HYQ12BBY

Replacement Remote 89070-42540, 89070-42660, 89070-42670, HYQ12BBY
Replacement Remote
1. Make sure these conditions are followed:
a. No keys in the ignition.
b. Driver's door is open others are closed.
c. Driver's door is unlocked.
2. Do this step twice in 5 seconds:
a. Insert the key in the ignition and pull it out. (Don't turn it)
3. These steps should be done within 40 seconds:
a. Close then open the Driver's door twice.
b. Insert the key in the ignition and pull it out. (Don't turn it)

4. Within 40 seconds, perform these steps:
a. Close then open the Driver's door twice.
b. Insert the key in the ignition.
c. Close the Driver's door.
d. Turn the key in the ignition to the ON position then turn it back off. (Make sure the engine did not start)
e. Take the key off the ignition.
5. In 3 seconds the door locks will lock and unlock. It means you're now in programming mode. If not, go back to step 1.

6. Within 40 seconds do these steps:
a. Press the lock and unlock buttons on your remote at the same time then release.
b. After doing step (a) press and hold the unlock button on your remote for 2 seconds. The door locks should lock then unlock within 3 seconds indicating that the programming is successful. If the door locks cycle twicem go back to step (a and b) since the system hasn't recognized the remote yet.
7. Open the driver's door.

No comments:

Post a Comment

Share