Tuesday, September 25, 2018

2003, 2004, 2005, 2006, 2007, 2008 Toyota Matrix Keyless Remote Programming Instructions

This keyless remote programming  instruction works on this 3B remote with part # 89742-02010 and FCC id GQ43VT14T

Replacement Remote 89742-02010, GQ43VT14T
Replacement Remote
1. Start with the following conditions:
a. Key is out of the ignition
b. Driver door is open (all other doors are closed)
c. Driver door is unlocked (other doors don’t matter).
2. Perform the next two steps within 5 seconds:
a. Insert the key into the ignition (don’t turn it) and pull it out.
b. Insert the key into the ignition (don’t turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. Close then open the driver’s door.
b. Close then open the driver’s door.
c. Insert the key into the ignition (don’t turn it) and pull it out.

4. Perform these steps within 40 seconds:
a. Close then open the driver’s door.
b. Close then open the driver’s door.
c. Insert the key into the ignition.
d. Close the driver’s door.
e. Turn the ignition to ON (as far as you can go without cranking your engine) then back to OFF.
f. Remove the key from the ignition.
5. Within 3 seconds, the power door locks should cycle (lock then unlock) automatically indicating successful entry into programming mode. Return to Step 1 if the locks do not cycle at this point.

6. Now, program your remote and do these steps within 40 seconds.
a. Press the lock and unlock buttons on the remote simultaneously and release it.
b. Press and hold the unlock button on your remote for 2 seconds. If the door locks cycles (lock and unlock) once within 3 seconds then you've successfully programmed your remote. If twice, then you need to go back to step a and b.
7. Once you're done, open your door (Driver's door) and do your thing.

No comments:

Post a Comment

Share