Friday, September 28, 2018

2003, 2004, 2005, 2006, 2007, 2008 Isuzu Ascender Keyless Remote Programming Instructions

This keyless remote programming instructions work for  remote with part # 15008008 #1 15008009 #2 15051014 FCC id MYT3X6898B on the back of it.

Replacement Remote 15008008, 15008009, 15051014, MYT3X6898B
Replacement Remote
Attention: Your system will delete every remote's code in it's memory once you've entered the programming mode. So, make sure to reprogram all of your old/existing remotes after dealing with the new one.

1. Before you start, close all the doors and wait for the dome light to go OFF.
2. Put the key in the ignition. (Don't turn it)
3. Press and hold the power UNLOCK button on the driver’s door panel until you've reached step 9.

4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).
6. Turn the ignition switch to the OFF position.

7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.

10. Press and hold the LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle. This step may take up to 30 seconds.
11. To program another remote just go back and re-do step 10.
12. To turn the programming mode OFF just turn the key in the ignition back to ON position.

No comments:

Post a Comment

Share