Friday, September 28, 2018

2003 ,2004, 2005, 2006 Gmc Sierra Keyless Remote Programming Instructions

This keyless remote programming instructions work for  remote with part # 15186203, 21997127, 15186200 #1, 15186201 #2, 15132197 #1, 15132198 #2, 10377295, 22730827 FCC id LHJ011 on the back of it.

Replacement Remote 15186203, 21997127, 15186200, 15186201, 15132197, 15132198, 10377295, 22730827, LHJ011
Replacement Remote
Your system will delete every remote's code in it's memory once you've entered the programming mode. So, make sure to reprogram all of your old/existing remotes after dealing with the new one.
1. Close all vehicle doors, windows closed, wait for dome light to go off.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).
6. Turn the ignition switch to the OFF position.
7. Twist the ignition switch to ON position. (Don't start the engine)
8. Twist the ignition switch back to the OFF.
9. Release the power unlock button on the door panel. Door locks should cycle (lock and unlock)
10. Press and hold LOCK and UNLOCK on the remote at the same time until the door locks cycle. Wait up to 30 seconds.
11. To program another remote just go back to step 10.
12. Turn the key in the ignition back to ON position to turn the programming mode OFF.

No comments:

Post a Comment

Share