Thursday, September 27, 2018

2002 Chevrolet Avalanche Keyless Remote Programming Instructions

This keyless remote programming instructions work for small ic chip remote with part # 15042968 FCC id KOBLEAR1XT and part # N board on the back of it.

Replacement Remote 15042968, KOBLEAR1XT
Replacement Remote
NOTE: Once your system is in programming mode it will automatically delete all saved remote's code from it's memory. Make sure to reprogram your existing remote after programming the new one.

1. Close all vehicle doors, windows closed, wait for dome light to go off.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the key in the ignition to ON position (don't start the engine).
6. Twist the key in the ignition back to OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
10. Press and hold the LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle. This step may take up to 30 seconds.
11. To program another remote just go back and re-do step 10.
12. To turn the programming mode OFF just turn the key in the ignition back to ON position.

No comments:

Post a Comment

Share