Friday, September 28, 2018

2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009 Gmc Envoy Keyless Remote Programming Instructions

This keyless remote programming instructions work for  remote with part # 15008008, #1 15008009, #2 15051014, FCC id MYT3X6898B. on the back of it.

Replacement Remote 15008008, 15008009, 15051014, MYT3X6898B
Replacement Remote
Please Note: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1. Close all vehicle doors, windows closed, wait for dome light to go off.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold down until instructed to release in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the ignition switch to the ON position (as far as you can go without starting the engine).
6. Turn the ignition switch to the OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
10. Press and hold the LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle. This step may take up to 30 seconds.
11. To program another remote just go back and re-do step 10.
12. To turn the programming mode OFF just turn the key in the ignition back to ON position.

No comments:

Post a Comment

Share