This keyless remote programming instruction works on this 3B remote with part # 89742-20200, 89742-0C020, 89742-42120 and FCC id HYQ12BAN, HYQ12BBX
a. Key is out of the ignition
b. Driver door is open (all other doors are closed)
c. Driver door is unlocked (other doors don’t matter).
2. Perform the next two steps within 5 seconds:
a. Insert the key into the ignition (don’t turn it) and pull it out.
b. Insert the key into the ignition (don’t turn it) and pull it out.
3. Perform these steps within 40 seconds:
a. Close then open the driver’s door.
b. Close then open the driver’s door.
c. Insert the key into the ignition (don’t turn it) and pull it out.
4. Within 40 seconds, perform these steps:
a. Close then open the Driver's door twice.
b. Insert the key in the ignition.
c. Close the Driver's door.
d. Turn the key in the ignition to the ON position then turn it back off. (Make sure the engine did not start)
e. Take the key off the ignition.
5. In 3 seconds the door locks will lock and unlock. It means you're now in programming mode. If not, go back to step 1.
6. Perform these steps within 40 seconds:
a. Press the lock and unlock buttons on the transmitter simultaneously for 1 second.
b. Immediately after releasing the lock and unlock buttons, press the unlock button by itself and hold for 2 seconds. Within 3 seconds, the door locks should cycle (lock then unlock) once indicating successful programming. If the door locks cycle twice, repeat steps 6a and 6b for this remote as it has not been accepted.
7. Open driver’s door.