Friday, September 28, 2018

2001, 2002, 2003, 2004 Gmc Sonoma Keyless Remote Programming Instructions

This keyless remote programming instructions work for small ic chip remote with part # 15042968 FCC id KOBLEAR1XT and part # N board on the back of it.

Replacement Remote 15042968, KOBLEAR1XT
Replacement Remote
INSTRUCTIONS:

Attention: Your system will delete every remote's code in it's memory once you've entered the programming mode. So, make sure to reprogram all of your old/existing remotes after dealing with the new one.

1. Close all the doors and windows, wait for the dome light to go OFF.
2. Put the key in the ignition.
3. Press and hold the power UNLOCK button on the driver’s door panel until you're instructed to release it in step 9.

4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the key in the ignition to ON position (don't start the engine).
6. Twist the key in the ignition back to OFF position.

7. Twist the ignition switch to ON position. (Don't start the engine)
8. Twist the ignition switch back to the OFF.
9. Release the power unlock button on the door panel. Door locks should cycle (lock and unlock)

10. Press and hold LOCK and UNLOCK on the remote at the same time until the door locks cycle. Wait up to 30 seconds.
11. To program another remote just go back to step 10.
12. Turn the key in the ignition back to ON position to turn the programming mode OFF.

No comments:

Post a Comment

Share