Friday, September 28, 2018

2001, 2002, 2003, 2004 Gmc Jimmy Keyless Remote Programming Instructions

This keyless remote programming instructions work for used to be 2300, 2301, 2310, 2311, 2235, 2236, 2080, 2020, 1070 remote with part # 25695954, 25695955, 25695966, 25695967, 15184352, 15184353, 15752330, 15043458, 10443537 FCC id KOBLEAR1XT and N board on the back of it.

Replacement Remote 25695954, 25695955, 25695966, 25695967, 15184352, 15184353, 15752330, 15043458, 10443537, KOBLEAR1XT
Replacement Remote
Attention: Your system will delete every remote's code in it's memory once you've entered the programming mode. So, make sure to reprogram all of your old/existing remotes after dealing with the new one.

1. Before you start, close all the doors and wait for the dome light to go OFF.
2. Put the key in the ignition. (Don't turn it)
3. Press and hold the power UNLOCK button on the driver’s door panel until you've reached step 9.
4. Do steps 5 through 8 in fairly rapid succession.
5. Twist the key in the ignition to ON position (Don't start the engine)
6. Twist the key in the ignition back to OFF.
7. Twist the ignition switch to ON position. (Don't start the engine)
8. Twist the ignition switch back to the OFF.
9. Release the power unlock button on the door panel. Door locks should cycle (lock and unlock)
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.
11. Repeat step 10 for each additional transmitter (including any existing  transmitters).
12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

No comments:

Post a Comment

Share