Friday, September 28, 2018

2001, 2002, 2003 Gmc Safari Keyless Remote Programming Instructions

This keyless remote programming instructions work for used to be 2300, 2301, 2310, 2311, 2235, 2236, 2080, 2020, 1070 remote with part # 25695954, 25695955, 25695966, 25695967, 15184352, 15184353, 15752330, 15043458, 10443537 FCC id KOBLEAR1XT and part # N board on the back of it.

Replacement Remote 25695954, 25695955, 25695966, 25695967, 15184352, 15184353, 15752330, 15043458, 10443537, KOBLEAR1XT
Replacement Remote
Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1. Close all the doors and windows, wait for the dome light to go OFF.
2. Put the key in the ignition.
3. Press and hold the power UNLOCK button on the driver’s door panel until you're instructed to release it in step 9.

4. Do steps 5 through 8 in fairly rapid succession.
5. Twist the key in the ignition to ON position (Don't start the engine)
6. Twist the key in the ignition back to OFF.

7. Twist the ignition switch to ON position. (Don't start the engine)
8. Twist the ignition switch back to the OFF.
9. Release the power unlock button on the door panel. Door locks should cycle (lock and unlock)

10. Press and hold the LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle. This step may take up to 30 seconds.
11. To program another remote just go back and re-do step 10.
12. To turn the programming mode OFF just turn the key in the ignition back to ON position.

No comments:

Post a Comment

Share