Tuesday, September 25, 2018

2000, 2001, 2002, 2003, 2004 Toyota mr2 Keyless Remote Programming Instructions

This keyless remote programming  instruction works on this 3B remote with part # 08191-00922 and FCC id BAB237131-056

Replacement Remote 08191-00922, BAB237131-056
Replacement Remote
1. Before going to programming mode make sure:
a. There are no keys in the ignition.
b. Your door (Driver's door) is open and unlocked others are closed.
2. Now, do this twice within 5 seconds:
a. Put your key in and out the ignition. (Don't start the engine)
3. Do these within 40 seconds:
a. Close then open the door twice.
b. Put your key in the ignition and pull it out once.

4. Now, do all these within 40 seconds:
a. Close then open the door twice.
b. Put the key in the ignition.
c. Close the door the again.
d. Turn the key to ON position in the ignition then turn it back OFF. (Again, don't start the engine)
e. Take the key off the ignition.
5. The door locks will cycle (lock and unlock) which means you're in programming mode. If not, then you need to start all over again.

6. Within 40 seconds do these steps:
a. Press the lock and unlock buttons on your remote at the same time then release.
b. After doing step (a) press and hold the unlock button on your remote for 2 seconds. The door locks should lock then unlock within 3 seconds indicating that the programming is successful. If the door locks cycle twicem go back to step (a and b) since the system hasn't recognized the remote yet.
7. Open the driver's door.

No comments:

Post a Comment

Share