Friday, September 28, 2018

2000, 2001 Chevrolet Tahoe Keyless Remote Programming Instructions

This keyless remote programming instructions work for big ic chip remote with part # 15732803, FCC id KOBUT1BT on the back of it.

Replacement Remote 15732803, KOBUT1BT
Replacement Remote
NOTE: Once your system is in programming mode it will automatically delete all saved remote's code from it's memory. Make sure to reprogram your existing remote after programming the new one.
1. Close all vehicle doors, windows closed, wait for dome light to go off.
2. Insert the key into the ignition.
3. Hold down the power UNLOCK button on the driver’s door panel-continue to hold down until instructed to release in step 9.
4. Do steps 5 through 8 in fairly rapid succession.
5. Twist the key in the ignition to ON position (Don't start the engine)
6. Twist the key in the ignition back to OFF.
7. Turn the ignition switch to ON position.
8. Turn the ignition switch back to the OFF position.
9. Release the power unlock button on the door panel. The door locks cycle (lock and unlock)
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until
the door locks and unlocks. This step may take up to 30 seconds.
11. Repeat step 10 for each additional transmitter (including any existing  transmitters).
12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

No comments:

Post a Comment

Share