Wednesday, September 19, 2018

1999 Plymouth Prowler Keyless Remote Programming Instructions

This keyless remote programming instruction works on this 3B remote with part # 56021903AA, 04686366AA, 4686076, 56008761, 56008762, 05014736AA and FCC id GQ43VT7T, GQ43VT9T

Replacement Remote 56021903AA, 04686366AA, 4686076, 56008761, 56008762, 05014736AA, GQ43VT7T, GQ43VT9T
Replacement Remote
1. Press the LOCK button 5 times on the existing (programmed) remote with 2 second intervals to resynchronize.
2. Turn the ignition to RUN position (Don't start the engine). Wait for chimes to stop.
3. Using the working (programmed) remote, press and hold the UNLOCK button on for between 4 and 10 seconds.
4. Within the specified 4 to 10 seconds, continue pressing the UNLOCK button and press the PANIC button (on the existing programmed remote) for 1 second and release both buttons. A chime will sound to indicate that the programming mode has been entered (allow 3 seconds for chime to sound).
5. Within 30 seconds of chime, press the LOCK and UNLOCK buttons at the same time then press and release just the UNLOCK button on the SAME remote. A chime will sound indicating the remote has been re-programmed. Repeat this step (press and release the LOCK and UNLOCK buttons at the same time then press and release just the UNLOCK button) for each new transmitter you wish to program. A chime will sound after each additional remote is programmed.
6. Turn the ignition OFF and remove the keys to exit the transmitter programming mode.
7. Test each transmitter for function.
Troubleshooting: If, at the “press and release just the UNLOCK button” in the second line at step 5, the
door locks unlock instead of give you a chime then you need to reverse steps 1 and 2.

No comments:

Post a Comment

Share