Thursday, September 27, 2018

1999, 2000 Cadillac Escalade Keyless Remote Programming Instructions

This keyless remote programming instructions work for 4B remote with part # 16245100rear2x, 16245104trunk, 16245100-29, 16207901-5 and FCC id AB01502T on the back of it.

Replacement Remote 16245100, 16245104, 16245100-29, 16207901-5, AB01502T
Replacement Remote
NOTE: Once your system is in programming mode it will automatically delete all saved remote's code from it's memory. Make sure to reprogram your existing remote after programming the new one.
1. Close all the doors and windows, wait for the dome light to go OFF.
2. Put the key in the ignition.
3. Press and hold the power UNLOCK button on the driver’s door panel until you're instructed to release it in step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the key in the ignition to ON position (don't start the engine).
6. Twist the key in the ignition back to OFF position.
7. Turn the ignition switch to ON position.
8. Turn the ignition switch back to the OFF position.
9. Release the power unlock button on the door panel. The door locks cycle (lock and unlock)
10. Press and hold the LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle. This step may take up to 30 seconds.
11. To program another remote just go back and re-do step 10.
12. To turn the programming mode OFF just turn the key in the ignition back to ON position.

No comments:

Post a Comment

Share