Friday, September 28, 2018

1998, 1999, 2000, 2001 Gmc Envoy Keyless Remote Programming Instructions

This keyless remote programming instructions work for used to be 2070, 2220, 2221, 2230, 2231, 2240 remote with part # 15732805, 25656444, 25656445, 25665574, 25665575, 25628814, 25668603, 25678792 FCC id KOBUT1BT and part # D board on the back of it.

Replacement Remote 15732805, 25656444, 25656445, 25665574, 25665575, 25628814, 25668603, 25678792, KOBUT1BT
Replacement Remote
IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1. Before you start, close all the doors and wait for the dome light to go OFF.
2. Put the key in the ignition. (Don't turn it)
3. Press and hold the power UNLOCK button on the driver’s door panel until you've reached step 9.
4. Perform steps 5 through 8 in fairly rapid succession.
5. Turn the key in the ignition to ON position (don't start the engine).
6. Twist the key in the ignition back to OFF position.
7. Turn the ignition switch to the ON position.
8. Turn the ignition switch to the OFF position.
9. Release the power unlock button on the door panel. The vehicle will lock and unlock the doors automatically.
10. Press and hold the LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle. This step may take up to 30 seconds.
11. To program another remote just go back and re-do step 10.
12. To turn the programming mode OFF just turn the key in the ignition back to ON position.

No comments:

Post a Comment

Share