Friday, September 28, 2018

1998, 1999, 2000 Gmc Sonoma Keyless Remote Programming Instructions

This keyless remote programming instructions work for big ic chip remote with part # 15732803 FCC id KOBUT1BT and part # D board on the back of it.

Replacement Remote 15732803, KOBUT1BT
Replacement Remote
IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1. Close all the doors and windows, wait for the dome light to go OFF.
2. Put the key in the ignition.
3. Press and hold the power UNLOCK button on the driver’s door panel until you're instructed to release it in step 9.
4. Do steps 5 through 8 in fairly rapid succession.
5. Twist the key in the ignition to ON position (Don't start the engine)
6. Twist the key in the ignition back to OFF.
7. Twist the ignition switch to ON position. (Don't start the engine)
8. Twist the ignition switch back to the OFF.
9. Release the power unlock button on the door panel. Door locks should cycle (lock and unlock)
10. Hold down the LOCK and UNLOCK buttons on the transmitter simultaneously until the door locks and unlocks. This step may take up to 30 seconds.
11. Repeat step 10 for each additional transmitter (including any existing transmitters).
12. Turn the ignition switch to the ON position in order to exit the transmitter programming mode.

No comments:

Post a Comment

Share