Saturday, September 29, 2018

1997, 1998, 1999, 2000 Chevrolet Tahoe Keyless Remote Programming Instructions

This keyless remote programming instructions work for 3B remote with part # 16245103trunk, 16245105rear2x, 16245100-2916207901-5 FCC id AB01502T on the back of it.

Replacement Remote 16245103, 16245105, 16245100-29, 16207901-5, AB01502T
Replacement Remote
Before entering programming mode, have in possession all of the transmitter you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program transmitters again.

1. Insert keys in ignition and leave it OFF position.
2. Locate the Data Line Connector (DLC) underneath the driver's side dasboard. Use the figures below as a map for your DLC (they usually aren't numbered) based on how your DLC is positioned. The view in the picture below is looking straight into the cavities of the DLC. Notice how the DLC is tapered on both ends: We will be working on the wider row of cavities (1 through 8 in the figure below).

3. Check if there are metal contact pins in terminals 8 and 4 and connect the Data Line Connector (DLC) terminal
8 to terminal 4 using a jumper wire. Door locks will cycle which means you're now in programming mode.
4. Press and hold LOCK and UNLOCK buttons on the remote at the same time until the door locks cycle (Lock and Unlock). Then release the buttons.

5. Repeat step 4 to program another remote.
6. Remove the jumper wire from the DLC (disconnect terminals 8 and 4).
7. You can now test all of your remotes.

No comments:

Post a Comment

Share